Mi-Waves’ 370 series flanged waveguide and 371 series unflanged waveguide is available in standard sizes from 12.6 to 320 GHz. The 370 series waveguide sections are fitted with Mi-Waves’ standard male/female flanges. Both waveguide types are manufactured primarily in copper. Standard WaveguideMIL-W-...

Mi-Waves’ 355 series rotary joints are available in standard circular waveguide sizes from 11.6 to 150 GHz. Each rotary joint consists of two circular waveguide sections mounted on ball bearings. Connections to the guides are made at standard male and female circular flanges. Precise alignment of the waveguid...

Mi-Waves’ 530 series manual switches are designed for use in standard millimeter wave frequency bands from 12.4 to 220 GHz. Each unit will operate over the full waveguide bandwidth with minimum insertion loss, minimum VSWR, and maximum isolation between coupled and uncoupled waveguide sections. Model Number53...

Mi-Waves’ 145 series polarization switch is a TE11 mode device with both the input and output in circular waveguide. It is equipped with a standard pin-aligned circular flange similar to most of Mi-Waves’ standard 200 series antenna components.Typical units are continuously adjustable over &plus...

Control InputTTL DC Power +5/-12Vdc With Driver +100/-10mA Operating Temperature0º C to +60º C Storage Temperature -55º C to +125º C VSWR1.5 Typical(Low Loss Condition) VSWR1.5 Typical(Low Loss Condition)

Mi-Waves’ 990 series balanced phase detectors feature a pair of Schottky diodes that that mix or beat two input signals at the same frequency to produce a DC output voltage proportional to the phase difference of the input signals. Matching the two Schottky diodes ensures low DC offset results as well as good...

Mi-Waves’ 950 series detectors convert incident RF energy into a DC voltage signal. The function of these detectors is similar to power sensors, with two exceptions. The 950 series detectors perform measurements more quickly and have a greater dynamic range than that obtainable from comparable power sensors. ...

Mi-Waves’ 340 series a critical consideration when using TE01 mode circular waveguide is the preservation of mode purity. Due to the similarities between the TE01 and TM11 modes, even the slightest irregularities in the circular waveguide will cause mode conversion from TE01 to TM11. And the large waveguide d...