Control InputTTL DC Power +5/-12Vdc With Driver +100/-10mA Operating Temperature0º C to +60º C Storage Temperature -55º C to +125º C VSWR1.5 Typical(Low Loss Condition) VSWR1.5 Typical(Low Loss Condition)

Mi-Waves’ 990 series balanced phase detectors feature a pair of Schottky diodes that that mix or beat two input signals at the same frequency to produce a DC output voltage proportional to the phase difference of the input signals. Matching the two Schottky diodes ensures low DC offset results as well as good...

Mi-Waves’ 950 series detectors convert incident RF energy into a DC voltage signal. The function of these detectors is similar to power sensors, with two exceptions. The 950 series detectors perform measurements more quickly and have a greater dynamic range than that obtainable from comparable power sensors. ...

Mi-Waves’ 340 series a critical consideration when using TE01 mode circular waveguide is the preservation of mode purity. Due to the similarities between the TE01 and TM11 modes, even the slightest irregularities in the circular waveguide will cause mode conversion from TE01 to TM11. And the large waveguide d...

Mi-Waves’ 450 series high pass filters use a simple yet effective waveguide cut-off filter technique. This design is useful for eliminating unwanted side bands in upconverters and out-of band frequencies in communication systems. These filters are small in size and compact by design. The 450 series can be des...

Mi-Waves’ 460 series band pass filter is primarily used for narrow band applications. Pass bands are typically from 1% to 4%. This design is well suited for frequency diplexers used in communicationsystems or any application where narrow bandwidths are required. Insertion losses are typically in the 0.8 dB to...

Mi-Waves’ 922 series harmonic mixers are used to downconvert millimeter wave signals using a Schottky barrier mixer diode and a Diplexer circuit to separate the local oscillator, and IF paths. Measurements can be made by mixing theharmonic of the LO with the desired RF signal and observing the resulting IF. R...

Mi-Waves’ 970 series balanced mixers have been designed to cover extremely wide RF bandwidths for EW/ELINT applications. These units offer excellent SSB conversion loss figures and are available up to 110 GHz. GaAs beam-lead diodes are used with a broadband circuit to provide excellent IF response. The 970 se...